Home - Forums - Documentation - Gallery - Bugs

The Rate Of A Travel Trailer


I went to a Recreational Vehicle program just recently with a good friend that had less understanding of the Recreational Vehicle industry. Why are travel trailers valued so differently?

While there are numerous elements that influence the rate, this write-up is going to attend to only 2 of them. When reviewing a travel trailer, you will observe that the outside is most likely light weight aluminum or fiberglass. The aluminum sided facilities are frequently called stick and container devices. The fiberglass sided systems are often a laminated unit.

A "stick and container" facility is developed with a wood frame, insulated with fiberglass insulation, and sided with aluminum. This facility is built similarly to your residence. The end and side walls are then covered with aluminum siding.

The laminated unit has an external layer of fiberglass on top of an aluminum frame. In between the light weight aluminum framing, they put styrofoam, then a layer of interior paneling. The wall surface then becomes one solid piece.

Both various kinds of construction are an identifying factor in cost. One must remember that it is much from all the elements that sets a travel trailer cost. One more point to remember is that, at times, a stick and tin device can be a lot more expensive than a laminated side wall surface system. This would certainly be the exception, and not the rule.

If you are not sure, simply ask the dealer that is attempting to offer you the system. If it is an individual, you could examine with your community RV dealership, or the producer of the facility to validate what building was made use of.

The Toronto siding contractors sided devices are usually called stick and tin systems. The fiberglass sided devices are normally a laminated device.

A "stick and container" system is developed with a wooden structure, insulated with fiberglass insulation, and sided with light weight aluminum. The laminated facility has an exterior layer of fiberglass on top of a light weight aluminum structure. Another point to don't forget is that, in some cases, a stick and tin device can be more expensive than a laminated side wall unit.

| User page | Discussion | View source | History |